Presenter Plate - Installation

INSTALLATION






NOTE: Transfer necessary parts if replacing the presenter assembly.

1. Position the folding top presenter plate assembly (3) onto the bottom side of the windshield header (1).
2. Install the presenter plate retaining bolts (2) finger tight.
3. Connect the presenter plate electrical connector located on the right A-pillar.
4. Connect the battery negative cable.
5. Close the folding top completely so that the header latches are fully latched.
6. Tighten the presenter plate retaining bolts (2) to 10 Nm (88 in. lbs.).
7. Cycle folding top open then closed to ensure proper presenter plate alignment.





8. Install the left and right A-pillar trim panels A-Pillar Trim Panel - Installation.
9. Install the windshield header lower trim panel (1) by pushing the panel upwards until the retaining clips are fully secured to the slots in the power folding top presenter plate assembly (2).





10. Position the left sun visor (2) into the vehicle.
11. Connect the left sun visor electrical connector (3).
12. Install the left sun visor retaining screws (1).
13. Repeat the installation procedure for the right sun visor.