Removal

REMOVAL





1. Remove the engine cover.
2. Remove the negative battery.
3. Drain the radiatorService and Repair.
4. Remove clamps at the lower radiator hose.
5. Remove the lower radiator hose.
6. Remove shift cable (1) from manual lever (2).




7. Remove the top valve body oil pan (1) bolts.




8. Remove the solenoid pack connector (2) at valve body oil pan (1).
9. Raise the vehicle on a hoist.
10. Remove the front left side inner wheel splash screws from front side of wheel opening.
11. Turn the wheel fully to the left.




12. Remove the pressure tap plug (2) at valve body oil pan.
13. Remove the lower valve body oil pan bolts (1) and drain transmission fluid.
14. Remove the valve body oil pan.




15. Remove the electrical connector (1) at the valve body (2).




16. Remove screw at detente arm (2).
17. Remove detente arm (1).




18. Remove the twenty one valve body to case bolts (1).




19. Insure the manual lever is fully forward to keep the manual valve pin (3) from binding.
20. Pull the valve body away from the underdrive compounder assembly oil transfer tubes (2) and lift up on valve body to clear the manual valve pin past the slot in the rooster comb.