Rear Exhaust Maniverter

INSTALLATION - REAR EXHAUST MANIVERTER

1. Clean gasket surfaces.
2. Position the maniverter and gasket. Install the retaining bolts. Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.).
3. Install and connect the rear maniverter upper oxygen sensor.
4. Install the rear maniverter upper heat shield.
5. Install the rear maniverter lower heat shield.
6. Install and connect the rear maniverter lower oxygen sensor.
7. Install the front extension pipe.
8. Install the exhaust maniverter cross under pipe Cross Pipe - Installation.
9. Install the center crossmember Service and Repair.
10. Install the bracket to bell housing retainer.
11. Position the extension pipe and install the retainer nuts.
12. Install the right front half shaft Half Shaft - Installation.




13. Install the belly pan (2) and the 12 belly pan fasteners (1).
14. Lower the vehicle.
15. Connect the negative battery cable Battery Reconnection.