Front Exhaust Maniverter

INSTALLATION - FRONT EXHAUST MANIVERTER





1. Position the maniverter and gasket. Install the retaining bolts. Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.).




2. Install the upper heat shield (2), and torque nuts (1) to 12 Nm (105 in.lbs).
3. Install and connect the front upper maniverter oxygen sensor.
4. Position the oil level indicator tube and install the retaining bolt.
5. Install and connect the front lower maniverter oxygen sensor.
6. Install the maniverter cross under pipe retaining bolts. Tighten bolts to 31 N.m (275 in. lbs.).




7. Install the belly pan (2) and the 12 belly pan fasteners (1).
8. Connect the negative battery cable Battery Reconnection.