Lower Intake Manifold

INSTALLATION - LOWER INTAKE MANIFOLD

1. Clean all sealing surfaces.
2. Position new gaskets and intake manifold on cylinder head surfaces.




3. Position the ignition coil capacitor and install the intake manifold bolts. Gradually tighten in sequence shown until a torque of 28 Nm (250 in. lbs.) is obtained.
4. Install fuel rail and injectors as an assembly.
5. Connect fuel supply hose to fuel rail.
6. Connect heater supply and return hoses to the intake manifold.
7. Connect electrical connectors to fuel injectors and coolant temperature sensor.
8. Install upper intake manifold Intake Manifold - Installation.
9. Connect the upper radiator hose to the thermostat housing.
10. Fill the cooling system Service and Repair.
11. Connect negative battery cable Battery Reconnection.