Power Brake Booster - Removal

GAS ENGINE

NOTE: Before proceeding, Brakes - Caution.

1. Disconnect and isolate the battery negative cable from its post on the battery.




2. Remove the powertrain control module (PCM) mounting fasteners and move the PCM aside. Powertrain Control Module - Removal
3. Remove the master cylinder. Master Cylinder - Removal




4. Disconnect the rear brake tubes (1) at the junction block (2). Install plugs at all of the open brake tubes.




5. Disconnect the vacuum hose (2) from the check valve (1) on the power brake booster. Do not remove the check valve from power brake booster.
6. Remove the steering column opening cover (and airbag if equipped) on the instrument panel. Steering Column Opening Cover - Removal




7. Remove the stop lamp switch (2) and discard it. Do not reuse the stop lamp switch. Removal




8. Remove the retaining clip (2) securing the power brake booster push rod (1) to the brake pedal. To do so, position a small screwdriver under the center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3). Remove and discard the clip. Do not reuse the clip.
9. Slide the booster push rod (1) off the brake pedal pin (3).




10. Remove the four nuts (4) attaching the power brake booster (3) to the dash panel.
11. Slide the power brake booster (3) forward until its mounting studs clear the dash panel, then remove it through the engine compartment.