Installation

INSTALLATION

NOTE: The ESP Off switch is serviced as part of the accessory switch bank.

NOTE: There are different instrument panel accessory switch banks available based on the option content of the vehicle. Ensure the accessory switch bank being installed matches the vehicle options.

1. Position the accessory switch bank onto the back of the instrument panel center bezel.
2. Install the screws that secure the accessory switch bank to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel Instrument Panel Center Bezel - Installation.
4. Reconnect the negative battery cable.
5. Perform the ABS Verification Test and make sure the ESP Off switch operates properly. ABS Verification Test
6. Verify proper operation of all components controlled by the switch bank.