Service Procedure

1. Place the window in the down position.

2. Open the driver's door and remove the side view mirror flag bezel from the door.





3. Using a small screwdriver, open the interior door release handle screw cover (Figure 1).

4. Remove the interior door release handle retaining screw (Figure 1).

5. Using a small screwdriver, remove the door pull cup screw cover (Figure 1).

6. Remove the two pull cup retaining screws (Figure 1).

7. Separate the door trim panel from the door shell.





8. Some vehicles may have a clear plastic hose and hose clamp attached to the release handle cable bezel (Figure 2).

> If the vehicle does not have a clear plastic hose and hose clamp, continue with Step 9 of this procedure.

> If the vehicle has a clear plastic hose and hose clamp perform the following procedure:

a. Slide the hose clamp off of the release handle cable bezel.

b. Slide the clear plastic hose off of the release handle cable bezel.

c. Disconnect the cable end from the interior door release handle arm.

d. Remove the cable from the interior door release handle cable bezel.

e. Remove and discard the hose clamp and clear plastic hose from the cable.

f. Insert the cable into the interior door release handle cable bezel.

g. Attach the cable end to the interior door release handle arm.

h. Continue with Step 9 of this procedure





9. Install one interior door latch cable retaining clip as shown in Figure 3.





10. Verify that the door latch cable is snapped into the cable retainer clip and then install the door trim panel to the door (Figure 4).

11. Install the two pull cup retaining screws (Figure 1).

12. Install the door pull cup screw cover (Figure 1).

13. Install the interior door release handle retaining screw (Figure 1).

14. Install the interior door release handle screw cover (Figure 1).

15. Install the side view mirror flag bezel.

16. Repeat Steps 1 through 15 of this procedure on the passenger side front door.