NGC

P1697-EMR (SRI) MILEAGE NOT STORED

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Ignition on and battery voltage greater than 10 volts.

- Set Condition:
The PCM Odometer mileage has not been programmed into the PCM.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.Initial Inspection and Diagnostic Overview

Diagnostic Test

1. PCM ODOMETER MILEAGE NOT PROGRAMMED
Turn the ignition on.
With the scan tool, attempt to perform the Program PCM Odometer function.
With the scan tool, clear DTCs.
Start the engine.
Allow the engine to reach normal operating temperature.
With a scan tool, select View DTCs.
Is the DTC Active at this time?

Yes

- Replace and program the Powertrain Control Module.
- Perform the PCM Verification Test. Powertrain Verification Test

No

- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the PCM Verification Test. Powertrain Verification Test