B2541

B2541-CONVERTIBLE TOP SENSE LIMIT SWITCH PERFORMANCE

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the Ignition Switch in the on position and the Power Top Control Module (PTCM) is awake.

- Set Condition:
This code will set when there is a timeout in the roof sequence because the Convertible Roof Sense Limit Switch is open for at least 40 ms.





Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, record and erase all PTCM DTC's.
Open and close the Convertible Top.
Wait 30 seconds.
With the scan tool, read all PTCM DTC's.
Does the scan tool display this DTC as active?

Yes

- Go to 2

No

- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test

2. (Q970) ROOF LIMIT SWITCH SENSE CIRCUIT SHORTED TO VOLTAGE




Turn the ignition off.
Disconnect the PTCM C1 harness connector.
Disconnect the Roof Sense Limit Switch harness connector.
Turn the ignition on.
Measure the voltage of the (Q970) Roof Limit Switch Sense circuit in the Roof Sense Limit Switch harness connector.
Is there any voltage present?

Yes

- Repair the (Q970) Roof Limit Switch Sense circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- Go to 3

3. (Q970) ROOF LIMIT SWITCH SENSE CIRCUIT OPEN




Turn the ignition off.
Measure the resistance of the (Q970) Roof Limit Switch Sense circuit between the PTCM C1 harness connector and the Roof Sense Limit Switch harness connector.
Does the ohm meter read open circuit?

Yes

- Repair the (Q970) Roof Limit Switch Sense circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- Go to 4

4. (Z907) GROUND CIRCUIT SHORTED TO VOLTAGE




Turn the ignition on.
Measure the voltage of the (Z907) Ground circuit in the Roof Sense Limit Switch harness connector.
Is there any voltage present?

Yes

- Repair the (Z907) Ground circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- Go to 5

5. (Z907) GROUND CIRCUIT OPEN




Turn the ignition off.
Measure the resistance between ground and the (Z907) Ground circuit in the Roof Sense Limit Switch harness connector.
Does the ohm meter read open circuit?

Yes

- Repair the (Z907) Ground circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- Replace the Power Top Control Module (PTCM).
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test