B2348

B2348 WIPER MOTOR LOW SPEED CONTROL CIRCUIT OPEN

For a complete wiring diagram Consult Diagrams/Electrical





Diagnostic Test

1. CONDITION PRESENT
Ignition on, engine off.
Turn the front wipers on.
Does the Front Washer Motor Function?

Yes

- Go to 2

No

- Go to 3

2. INTERMITTENT WIRING AND CONNECTORS
Turn the ignition on.
With the scan tool, erase all TIPM DTCs.
Turn the ignition off.
The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wiring while checking for shorts and open circuits.
Were there any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Test Complete.

3. FUSED ACCESSORY RELAY OUTPUT CIRCUIT
Turn the ignition off to the lock position.
Disconnect the Front Wiper Motor harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Ignition on, engine off.
Using a 12-volt test light connected to ground, check the Fused Accessory Relay Output circuit in the Front Wiper Motor harness connector.
Does the test light illuminate brightly?

Yes

- Go to 4

No

- Repair the Fused Accessory Relay Output circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

4. FRONT WIPER MOTOR
Turn the ignition off to the lock position.
Disconnect the Front Wiper Motor harness connector.
Ignition on, engine off.
Using a 12-volt test light connected to 12 Volts, check the (W3) Front Wiper Low Speed Control Output circuit in the Front Wiper Motor harness connector while turning on the Front Wipers.
Does the test light illuminate brightly?

Yes

- Replace the Front Wiper Motor.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go to 5

5. (W3) FRONT WIPER LOW SPEED CONTROL OUTPUT CIRCUIT OPEN




Turn the ignition off to the lock position.
Disconnect the TIPM C11 harness connector.
Disconnect the Front Wiper Motor harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Measure the resistance of the (W3) Front Wiper Low Speed Control Circuit from the TIPM C1 connector to the Front Wiper Motor harness connector.
Is the resistance above 5.0 ohms?

Yes

- Repair the (W3) Front Wiper Low Speed Control Circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go to 6

6. (W3) FRONT WIPER LOW SPEED CONTROL OUTPUT CIRCUIT SHORT TO VOLTAGE




Turn the ignition off to the lock position.
Disconnect the TIPM C11 harness connector.
Disconnect the Front Wiper Motor harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Turn the ignition on.
Using a 12-volt test light connected to ground, check the (W3) Front Wiper Low Speed Control Output circuit.
Does the test light illuminate brightly?

Yes

- Repair the (W3) Front Wiper Low Speed Control Output circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test