Installation

INSTALLATION





NOTE: If valve body assembly is being replaced or reconditioned, the "Quick-Learn" procedure must be performed Quick Learn Procedure.

1. Install valve body assembly to transaxle.




2. Install and torque valve body-to-transaxle case bolts to 12 Nm (105 in. lbs.).




3. Install transaxle oil filter. Inspect the o-ring and replace if necessary.




4. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of Mopar(R) Silicone Rubber Adhesive Sealant to the oil pan and install.




5. Torque oil pan-to-transaxle case bolts to 19 Nm (165 in. lbs.).
6. Lower vehicle.
7. Connect transmission range sensor connector.
8. Install manual valve lever to manual shaft.
9. Install gearshift cable to manual valve lever.
10. Connect battery negative cable.
11. Fill transaxle with Mopar(R) ATF +4 Transmission fluid. Fluid Level and Condition Check - 40/41TE