Installation

BULBS

HEADLAMP HIGH BEAMS





CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface. Reduced bulb life will result.

1. Position the headlamp bulb (1) in the front lamp unit.
2. Grasp the bulb and twist clockwise 1/4 turn.
3. Connect the headlamp bulb electrical connector.
4. Connect the battery negative cable.
HEADLAMP LOW BEAM DRIVER SIDE

5. Position the headlamp bulb in the front lamp unit.
6. Grasp rear of bulb and twist clockwise 1/4 turn.
7. Connect the headlamp bulb electrical connector.
8. Reposition the power distribution center and clip into bracket.
- Reposition the air intake housing and move to side.
- Install the one retaining bolt.
- Connect the air intake sensor connector.

9. Loosen air intake housing and move aside.
10. Connect the battery negative cable.
HEADLAMP LOW BEAM PASSENGER SIDE

11. Position the headlamp bulb in the front lamp unit.
12. Grasp the bulb and twist clockwise 1/4 turn.
13. Connect the headlamp bulb electrical connector.
14. Connect the battery negative cable.
TURN SIGNAL / SIDE MARKER





15. Position the turn signal bulb (3) in the front lamp unit (2).
16. Twist the bulb socket (3) clockwise 1/4 turn.
17. Connect the turn signal lamp electrical connector (1).
18. Connect the battery negative cable.