Installation

INSTALLATION





1. Maneuver the driver surround bezel (1) around the steering wheel and multi-functions switches.
2. Install the screws (3) to the bezel:
- Three inside the knee blocker opening
- One underneath the left end cover
- One on the A-pillar
- One under the center console bezel left side

3. Connect the decklid release switch electrical connector and push in the switch (2).
4. Install the center console bezel Center Console Bezel - Installation.
5. Install the cowl trim panel Cowl Trim - Installation.
6. Install the door sill trim Door Sill Scuff Plate - Installation.
7. Install the knee bolster Installation.
8. Install the steering column opening cover Steering Column Opening Cover - Installation.
9. Install the cluster bezel Instrument Panel Cluster Bezel - Installation.
10. Connect the battery negative remote cable.