Removal

REMOVAL

NOTE: Before proceeding, Brakes - Caution.

NOTE: The procedure below applies to either of the two rear parking brake cables.

1. Disconnect and isolate the battery negative cable from its post on the battery.
2. Block the tire and wheel assemblies so the vehicle does not move once the vehicle parking brake lever is released.




3. Remove the center console. Center Console - Removal
4. Release and lower the parking brake lever (3).




5. Loosen the adjusting nut on the lever's output cable taking tension off parking brake cables. Back the nut off until it is flush with the end of the output cable.
6. Remove the parking brake cables (1) from the parking brake cable equalizer (2).




7. Disconnect the wiring harness connector (1) from the parking brake switch (2).




8. Remove the nuts (1) attaching the parking brake lever (2) to the vehicle.
9. Remove the parking brake lever (2).