Installation

INSTALLATION





1. Install the wheel cylinder onto the brake support plate. Install and tighten the mounting screws (1) to 13 Nm (115 in. lbs.).
2. Hand start the brake tube nut (2) into the wheel cylinder (1). Tighten the tube nut to 17 Nm (150 in. lbs.).




NOTE: Inspect the brake shoes before installation. Brake Pads - Inspection

3. Install the drum brake shoes (6) and drum. Adjust shoes as necessary. Brake Pads - Installation




4. Install the tire and wheel assembly (1) Tires and Wheels - Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
5. Slowly rotate the rear wheel and verify that the brake drum lightly drags on the shoes.
6. Lower the vehicle.




7. Remove the brake pedal holder.
8. Bleed the wheel cylinder as necessary. Brake Bleeding
9. Road test the vehicle to make sure the brakes operate correctly.