B2206

B2206-CURRENT VIN MISSING/MISMATCH

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Anytime the ignition key is in the ON position.

- Set Condition:
VIN stored in Intrusion Transceiver Module does not match the VIN stored in the Cluster.





Diagnostic Test

1. DETERMINING IF DTC IS CURRENT
With a scan tool, read and record DTC(s).
With the scan tool, clear DTC(s).
Turn the ignition off and remove the key from the ignition.
Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
Disarm the VTSS.
Using the scan tool, read ITM DTC(s).
Does the DTC reset?

Yes

- Using the scan tool under Miscellaneous functions initialize the Intrusion Transceiver Module.
- Perform the BODY VERIFICATION TEST - VER 1Body Verification Test

No

- DTC is not active at this time. Test complete.
- Perform the BODY VERIFICATION TEST - VER 1Body Verification Test