Engine Oil Pump - Installation

INSTALLATION





CAUTION: Crankshaft position must be at 60° ATDC of No.1 cylinder before installing oil pump. This position will properly locate oil pump. If not properly located, severe damage to oil pump can occur.

1. Prime oil pump before installation by filling rotor cavity with engine oil.
2. If crankshaft has been rotated, it must be repositioned to 60° ATDC of No.1 cylinder prior to oil pump installation.




3. Install oil pump carefully over crankshaft and into position.
4. Install oil pump attaching bolts (1). Tighten bolts to 28 Nm (250 in. lbs.).
5. Install oil pick-up tube (3) with new O-ring. Lubricate O-ring before installation. Tighten attaching bolts to 28 Nm (250 in. lbs.).
6. Install oil pan. Engine Oil Pan - Installation
7. Install timing chain and sprockets. Timing Chain & Sprockets - Installation
8. Install timing chain cover. Timing Cover - Installation
9. Install crankshaft vibration damper. Vibration Damper - Installation
10. Fill crankcase with engine oil to correct level.