Airbag System Verification Test

*AIRBAG SYSTEM VERIFICATION TEST - VER 1

1. *AIRBAG SYSTEM VERIFICATION TEST - VER 1
1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. With the scan tool, erase stored DTCs in all Airbag System Modules.
4. Turn the ignition off, and wait 30 seconds, then turn the ignition on.
5. Wait one minute, and read active DTCs in all Airbag System Modules.
6. Read the stored DTCs in all Airbag System Modules.
Are any DTCs present or if the original condition still present?

Yes

- Diagnose and repair the DTC(s).

No

- Repair is complete.