NGC

P0480-COOLING FAN 1 CONTROL CIRCUIT





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on. Battery voltage greater than 10 volts.

- Set Condition:
An open or shorted circuit is detected in the Low/High Rad Fan Control circuit. One Trip Fault. Three good trips to turn off the MIL.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.Initial Inspection and Diagnostic Overview

Diagnostic Test

1. RADIATOR COOLING FAN MODULE OPERATION
Ignition on, engine not running.
With a scan tool, select Radiator Cooling Fan Relay #1 Control State to actuate the Cooling Fan (Low/High).
Is the one Cooling Fan operating?

Yes

- Refer to the *CHECKING FOR AN INTERMITTENT DTC Diagnostic Procedure. Checking For An Intermittent DTC
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Go to 2

2. (A16) FUSED B+ CIRCUIT




Ignition on.
Disconnect the Low/High Rad Relay harness connector.
Using a 12-volt test light connected to ground, probe the (A16) Fused B+ circuit in the Low/High Rad Relay harness connector.
Does the test light illuminate brightly?

Yes

- Go to 3

No

- Repair the (A16) Fused B+ circuit. Inspect the related fuse and repair as necessary.
- Perform the PCM Verification Test. Powertrain Verification Test

3. LOW/HIGH RAD FAN CONTROL CIRCUIT




Ignition on, engine not running.
With a scan tool, select Radiator Cooling Fan Relay #1 Control State, Toggle, to actuate the Cooling Fan (Low/High).
Using a 12-volt test light connected to battery voltage, probe the (N201) Low/High Rad Fan Control circuit in the Low/High Rad Relay harness connector.
Does the test light illuminate brightly and flash on and off?

Yes

- Replace the Low/High Rad Fan Relay.
- Perform the PCM Verification Test. Powertrain Verification Test

No

- Go to 4

4. (N201) LOW/HIGH RAD FAN CONTROL CIRCUIT SHORTED TO BATTERY VOLTAGE




Disconnect the TIPM C11 harness connector.
Using a voltmeter, measure the voltage of the (N201) Low/High Rad Fan Control circuit in the Low/High Rad Relay connection.
Is there voltage present?

Yes

- Repair the short to voltage in the (N201) Low/High Rad Fan Control circuit.
- Perform the PCM Verification Test. Powertrain Verification Test

No

- Go to 5

5. (N201) LOW/HIGH RAD FAN CONTROL CIRCUIT OPEN




Measure the resistance of the (N201) Low/High Fan Control circuit from the Low/High Rad Relay harness connector to the TIPM C11 harness connector.
Is the resistance below 5.0 ohms?

Yes

- Go to 6

No

- Repair the open in the (N201) Low/High Fan Control circuit.
- Perform the PCM Verification Test. Powertrain Verification Test

6. (N201) LOW/HIGH RAD FAN CONTROL CIRCUIT SHORTED TO GROUND




Measure the resistance between ground and the (N201) Low/High Fan Control circuit in the TIPM C11 harness connector.
Is the resistance below 100 ohms?

Yes

- Repair the short to ground in the (N201) Low/High Fan Control circuit.
- Perform the PCM Verification Test. Powertrain Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the PCM Verification Test. Powertrain Verification Test