B2367

B2367-WINDOW WASHER MOTOR 1 CONTROL CIRCUIT

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
- With the ignition on.
- Set Condition:
- The TIPM detects an open condition.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all TIPM DTC's.
Turn the Front Wipers on.
With the Scan Tool, read the Front Wiper DTC's.
Does the Scan Tool read: B2367-WINDOW WASHER MOTOR 1 CONTROL CIRCUIT?

Yes

- Go to 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test


2. (W10) FRONT WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO VOLTAGE




Turn the ignition off.
Disconnect the Front Washer Pump Motor harness connector.
Disconnect the TIPM C1 harness connector.
Measure the voltage on the (W10) Front Washer Pump Motor Control circuit.
Is the voltage above 5.0 volts?

Yes

- Repair the (W10) Front Washer Pump Motor Control circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test