B223B

B223B-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Anytime the ignition key is in the ON position.

- Set Condition:
If the Intrusion Transceiver Module configuration does not match the Intrusion sensor.





Diagnostic Test

1. CONFIGURE THE INTRUSION TRANSCEIVER MODULE
NOTE: Before proceeding check the vehicles Intrusion Sensor for the correct part number for this vehicle and replace if necessary.

Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.
With the scan tool, clear DTC(s).
Turn the ignition off and remove the key from the ignition.
Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
Disarm the VTSS.
Using the scan tool, read DTC(s).
Does the DTC reset?

Yes

- Replace the Intrusion Transceiver Module.
- Perform BODY VERIFICATION TEST - VER 1Body Verification Test

No

- DTC is not active at this time. Test complete.
- Perform BODY VERIFICATION TEST - VER 1Body Verification Test