Vehicle Theft Security

B210E-BATTERY VOLTAGE HIGH - (WCM)

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Ignition key in any position but run.

- Set Condition:
The Sentry Key Remote Entry Module (SKREEM) has detected the Fused (B+) input voltage above 16 volts in all Key Positions except for RUN.





Diagnostic Test

1. DETERMINING IF DTC IS CURRENT
CAUTION: Diagnose and repair all Powertrain DTCs before continuing.

Turn the ignition on.
With the scan tool, record and erase the SKREEM DTCs.
Perform 5 ignition cycles, leaving the ignition switch on for a minimum of 90 seconds per cycle.
Using the scan tool, read the SKREEM DTCs.
Does the DTC reset?

Yes

- Replace and program the SKREEM.
- Perform the SKREEM VERIFICATION TEST. Vehicle Theft Security Verification Tests

No

- The DTC is not active at this time. Test complete.