B142F

B142F-SATELLITE RADIO ANTENNA NOT CONNECTED

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
- With the ignition on and the Satellite Radio in seek mode.
- Set Condition:
- With the radio in seek mode for two loops around the band. The radio does not detect an antenna connection or does not receive a radio satellite signal.





Diagnostic Test

1. TEST ANTENNA
Turn the ignition off.
Disconnect the Satellite Radio Antenna connector.
Inspect the Satellite Radio Antenna connection.
Was the Antenna connection clean and secure?

Yes

- Go to 2

No

- Repair the Antenna connection as needed.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. SATELLITE RADIO ANTENNA
Refer to the Audio System and test the antenna.
Is the Antenna ok?

Yes

- Go to 3

No

- Repair or replace the Antenna assembly as necessary.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

3. SATELLITE RADIO RECEIVER
NOTE: Reconnect all previously disconnected components.

NOTE: Move vehicle outside approximately 30ft (9.144m) from any structure.

Turn the ignition and radio on.
With the scan tool, erase the audio DTC's, put the satellite radio in seek up and down mode for 2 loops around the band cycle before proceeding.
With the scan tool, read the audio DTC's.
Did this DTC reset?

Yes

- Replace the Satellite Radio Receiver.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Test Complete.