Service Procedure

1. Disconnect the negative battery cable.

NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.

2. Partially lift the vehicle on an appropriate frame contact hoist.

3. Remove the left front wheel and tire.

4. Remove the rear section of the left front plastic inner fender splash shield.





5. Locate the unused 6-cavity tire pressure monitor electrical connector that is tie strapped to the main wiring harness (Figure 1).

6. Cut off and discard the plastic tie strap that holds the 6-cavity unused electrical connector to the main wiring harness (Figure 1).





7. Using diagonal pliers, cut off and discard the 6-cavity unused tire pressure monitor electrical connector (Figure 2).

8. Remove approximately 2 inches (50 mm) of protective tape from the wires cut in Step 7.





9. Place a piece of heat shrink tube over each individual wire end and heat the shrink tube until glue comes out of both ends of the shrink tube (Figure 3).

10. Tape back the sealed wires to the main electrical wiring harness.

11. Install the plastic inner fender splash shield.

12. Install the wheel and tire assembly. Tighten the lug nuts to 100 ft. lbs. (135 N.m).

13. Lift the vehicle all the way up on the hoist.





14. Inspect the left and right rear wheel well areas to determine if there is an unused left and right side rear tire pressure monitor electrical connector (Figure 4).

> Vehicles with unused electrical connectors, continue with Step 15.

> Vehicles without unused electrical connectors, continue with Step 22.

15. Cut off plastic tie strap that holds the unused left and right rear tire pressure monitor electrical connector to the body wiring harness.

16. Pull the body wiring harness from the body studs.

17. Using diagonal pliers, cut off and discard the right and left side rear unused tire pressure monitor electrical connectors.

18. Remove approximately 2 inches (50 mm) of protective tape from the wires cut in Step 17.

19. Place a piece of heat shrink tube over each individual wire end and heat the shrink tube until glue comes out of both ends of the shrink tube (Figure 2).

20. Tape back the sealed wires to the body wiring harness.

21. Connect the body wiring harness to the body studs.

22. Lower the vehicle from the hoist.

23. Connect the negative battery terminal.

24. Clear all Diagnostic Trouble Codes (DTC's) using the following procedure:

a. Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle data link connector.

c. Power "ON" the StarSCAN tool.

d. Starting at the "Home" screen, select "System View".

e. Select "All DTC's".

f. Select "Clear All Stored DTC's" and follow the on-screen instructions.

g. Select "YES" in the pop-up box.

h. Start the engine and verify that there are no DTC's.

i. Turn off the engine and disconnect the StarSCAN from the vehicle.