Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Put decklid in the service position, Decklid Service Position.
3. Remove the cylinder rear retaining clip and pin (2).
4. Disconnect the folding top stack cylinder position switch (1) electrical connector.
5. Raise the rear of the folding top stack cylinder upward to gain access to the cylinder position switch (4).




6. Using a small flat bladed screwdriver or other suitable tool, gently slide the position switch retainer locking tab (1) away from the retainer (4).
7. Slide the position switch retainer (4) away from the switch (2).
8. Lift the position switch (2) off of the folding top stack cylinder (3).
9. Disconnect any position switch wire harness routing clips and remove the switch from the vehicle.