Deckbar

REMOVAL





NOTE: The hydraulic system uses ARAL VITAMOL ZH-M fluid. When replacing components or topping off system due to leak, make sure to use only approved fluid. When adding fluid Convertible Top - Standard Procedure.

1. Open decklid conventionally,
2. Disconnect and isolate the battery negative remote cable.
3. Remove the rear trunk trim.
4. Remove the trunk side trim.
5. Remove the spare tire cover/floor of the trunk.
6. Release the pump pressure valve (1) by turning it 90° either way.

NOTE: The pump valve will be oriented straight up and down when released.





7. Remove the cylinder fasteners and lift cylinder off of the deckbar.




8. At the hydraulic cylinder, slide the retaining clamp off and pull out line.

CAUTION: Be careful to catch all fluid in a catch container.