Installation

INSTALLATION

CONVERTIBLE





1. Clean body surface with Mopar(R) Super Kleen solvent or equivalent. Wipe surface dry with a lint free cloth.
2. Apply a length of masking tape on the body parallel to the top edge of the molding to use as a guide, if necessary.
3. Remove protective cover from tape on back of molding. Apply molding to body below the masking tape guide.
4. Remove masking tape guide. Heat body metal and body side molding to approximately 38° C (100° F) using a suitable heat lamp or heat gun.
5. Firmly press body side molding to body surface to insure adhesion.
SEDAN





6. If molding is to be reused, remove tape residue from molding. Clean back of molding with Mopar(R) Super Kleen solvent or equivalent. Wipe molding dry with lint free cloth. Apply new body side molding (two sided adhesive) tape to back of molding.