Washer Reservoir - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Remove screws at the left wheel opening splash shield.
4. Remove the lower fascia push pins.
5. Remove upper bolts at ends (ears).
6. Disengage lower fascia to grille clips.
7. Pull away fascia as necessary to access reservoir (5).
8. Disconnect the hoses and electrical connectors from the reservoir.
9. Remove three retaining bolts.
10. Pull reservoir (5) from filler tube (7).
11. Transfer pumps. Make sure to use a new grommet.
12. Transfer sensor. Make sure to use a new grommet.
13. Drain fluid into new reservoir (5).