Installation

INSTALLATION





1. Maneuver filler tube (7) into mounting location within engine compartment.
2. Install the one retaining bolt at upper filler tube (7).
3. Slip reservoir (5) up into filler tube (7).
4. Install the three reservoir mounting bolts.
5. Engage lower fascia to grille clips.
6. Install the upper bolts at ends (ears).
7. Install the lower fascia push pins.
8. Install the screws at the left wheel opening splash shield.
9. Remove vehicle off of hoist.
10. Connect the battery negative cable.
11. Top off washer fluid.
12. Close hood.