Front Door Glass Run Channel - Installation

INSTALLATION

1. Place door glass run into position.
2. Insert A-pillar section of door glass run into door through belt line and lower to bottom of door using molded corner as guide.
3. Locate top corner portion of the B-pillar door glass run section into the glass run channel and slide it up until the part bottoms out on the header portion of the glass run channel.

NOTE: Do not JAM the corner into place.

4. Install entire B-pillar door glass run into glass run channel.
5. Starting at the B-pillar corner, install 8 to 10 inches of the header glass run into the glass run channel.

NOTE: Care must be taken to avoid pushing or pulling the header section and the molded corner off location.

6. Install A-pillar door glass run section by indexing the molded corner detail into he glass run channel. Slide the glass run up the A-pillar until the rubber molded joint just touches the frame.
7. Install fully the entire A-pillar door glass run into the glass run channel.
8. Working from A-pillar rearward, install header portion of the door glass run into the glass run channel.
9. Verify the door glass run is fully seated in the header, A-pillar and B-pillar.
10. Install inner belt weatherstrip.
11. Install door trim panel. Front Door Trim Panel - Installation.