Shaft Silencer Shell/Cover Seal - Installation

INSTALLATION





1. Place intermediate shaft cover (1) over intermediate shaft (6) and extension onto mounting studs on dash panel.
2. Slide intermediate shaft silencer shell (3) over intermediate shaft (6) and onto studs on dash panel while inserting lower mounting stud though cover and dash panel.
3. Install two upper intermediate shaft silencer shell/cover mounting nuts (4). Tighten nuts to 2.8 Nm (25 in. lbs.).
4. Raise and support vehicle. Maintenance




5. Install lower silencer shell/cover mounting nut (5). Tighten nuts to 2.8 Nm (25 in. lbs.).
6. Ensure intermediate shaft cover shield (1) is extended down over top of gear housing closing off shaft area.
7. Lower vehicle.




8. Connect steering column coupling to intermediate shaft. To do so:
a. Match intermediate shaft (1) to coupling pinch loop.
b. Install coupling pinch bolt (8). Tighten to 28 Nm (21 ft. lbs.).
c. Install hair pin (7) through end of pinch bolt.




9. Remove steering wheel holder.
10. Connect battery negative (-) cable to battery post.
11. Road test vehicle to ensure proper operation of steering.