Horn Switch: Description and Operation

REMOVAL

WARNING: This system is a sensitive, complex unit. Disconnect and isolate the battery negative cable before beginning airbag system component removal or installation procedures. This will disable the airbag system. Failure to disconnect the battery could result in accidental airbag deployment and possible personal injury.
Allow system capacitor to discharge for two minutes before removing airbag components.

Do not place an intact undeployed airbag face down on a solid surface, the airbag will propel into the air if accidentally deployed and could result in personal injury. When carrying or handling an undeployed airbag, the trim side of the airbag should be pointing towards the body to minimize possibility of injury if accidental deployment occurs.






1. Disconnect and isolate the battery negative cable.
2. Remove the driver's side airbag Driver Airbag - Removal.
3. Remove the airbag trim cover Driver Airbag - Removal.
4. Disconnect the black wire from the air bag.
5. Remove only the thin membrane switch from the airbag. Do not remove the hard backer plate from the airbag.