Removal

REMOVAL

NOTE: The rear blower motor switch and the rear floor console switch bezel are serviced only as an assembly.





1. Disconnect and isolate the negative battery cable.
2. Remove the rear floor console (6) and place it on a workbench Floor Console - Removal.
3. Remove the rear floor console switch bezel (1) by releasing the retaining tab (3) located at each end of the switch bezel and pushing it out through the front surface of the console.
4. Disconnect the wire harness connectors (4 and 7) from the rear blower motor switch (5) and both rear heated seat switches (2).
5. Remove the rear heated seat switches from the rear floor console switch bezel by gently prying the switches free from the back of the switch bezel 2nd Row.