Occupant Restraint Controller - Installation

INSTALLATION





1. Position ORC (1) in vehicle on top of the floor tunnel (5).
2. Install the three retaining screws (2) to the ORC (1). One on the left side of the floor tunnel (5), and one in front of (toward bulkhead) and behind (toward vehicle rear) the ORC unit. Tighten screws to 14.5 Nm (128 in. lbs.).




3. From the right side of the vehicle, connect the two ORC electrical connectors (2 and 3, referred to as C1 and C2 in the diagnostic information and wiring).




4. Install the left and right forward console closeout panels (1).

WARNING: Do not connect the battery negative cable Refer to appropriate testing. Personal injury may result if the system test is not performed first.

WARNING: Following successful completion of the Airbag System test procedure, the Occupant Classification System Verification Test must be done using a scan tool and the appropriate diagnostic information.

5. Close hood.