Installation

INSTALLATION





NOTE: The O-rings should be placed on the regulator first, to prevent them from being rolled out of position during regulator install.

1. Lightly lubricate the O-rings with clean engine oil and place them onto regulator.
2. Push regulator down and into place.
3. Install ground wire.
4. Install module and gasket seal.
5. Ensure seal is properly positioned in fuel tank groove.
6. Install the module lock ring.

NOTE: Use a brass punch to Install the 1/4 turn lock ring. Make sure all 5 tabs are properly seated.

7. Connect fuel line and vapor lines.




8. Install fuel tank, Fuel Tank - Installation.
9. Connect negative battery cable.
10. Fill fuel tank. Use the scan tool to pressurize the fuel system. Check for leaks.