Removal

HEADLAMP BULBS

HALOGEN HEADLAMP

1. Remove the front lamp unit Front Lamp Unit - Removal.
2. Disconnect the lamp electrical connector.
3. Remove the rubber boots/seals protecting the lamp from the elements.
4. Twist lamp socket out of headlamp housing.

HIGH INTENSITY DISCHARGE HEADLAMPS (IF EQUIPPED)

HID BULB

1. Remove the front lamp unit Front Lamp Unit - Removal.
2. Remove the rubber boots/seals protecting the lamp/igniter from the elements.
3. Grab the igniter and twist counterclockwise approximately 1/4 turn. There is an arrow pointing which direction to turn. The igniter electrical connector will disengage when this happens, unlocking the igniter from the HID lamp.
4. Pull the igniter straight out of the headlamp unit.
5. Pull lamp straight out of igniter.
IGNITER

6. Remove the front lamp unit Front Lamp Unit - Removal.
7. Remove the rubber boots/seals protecting the lamp/igniter from the elements.
8. Grab the igniter and twist counterclockwise approximately 1/4 turn. There is an arrow pointing which direction to turn. The igniter electrical connector will disengage when this happens, unlocking the igniter from the HID lamp.
9. Pull the igniter straight out of the headlamp unit.
BALLAST MODULE





10. Remove the front lamp unit Front Lamp Unit - Removal.
11. Remove the three retaining screws.




12. Remove the ballast module from headlamp unit.