Fog Lamp - Installation

FOG LAMP UNIT





NOTE: If replacing fog lamp unit with new, the fog lamp must be transferred to the new unit.

CAUTION: Do not touch the glass of fog lamps with fingers or other possibly oily surface. Reduced lamp life will result.

1. Connect the electrical connection to the fog lamp (2).
2. Make sure as you install the fog lamp unit (2) into the fascia (3), the rear indexing dowels are properly lined up.
3. Push the fog lamp unit straight into the front fascia.
4. Install two retaining screws (4).
5. Install the lower fascia/belly pan and push pins.
6. Install the push pins and screws to the lower portion of the front wheelhouse splash shield Front Wheelhouse Splash Shield - Installation.
7. Connect the battery negative cable.
8. Close hood.