Removal - Rear

REMOVAL





1. Remove the cover from the front center floor console . Floor Console - Removal
2. Disconnect and isolate the negative battery cable.
3. Disconnect the body wire harness connectors from the rear blower motor power module (2) and the rear mode door actuator (6).
4. Remove the body wire harness from the rear console support bracket (7).
5. Remove the eight screws (3) that secure the front console support bracket (1) and the rear console support bracket to the floor console base and duct assembly and remove the support brackets.
6. Remove the four screws (4) that secure the rear blower motor housing (5) to the floor console base and duct assembly.
7. Remove the rear blower motor housing and place it on a bench.
8. Disconnect the rear blower motor wire harness connector from the power module.
9. Remove the eleven retaining clips and three screws that secure the rear blower motor housing together and separate the housing halves.




10. Remove the blower motor wire harness and grommet (2) from the lower rear blower motor housing (3) and remove the rear blower motor (1).
11. If required, remove the center console mode-air doors (4) from the lower rear blower motor housing.