4 Passenger Seating

4 PASSENGER SEATING





1. Position the floor console base and duct assembly (7) into the vehicle and connect it to the floor distribution duct (14).
2. Install the nine nuts (1) onto the weld studs (13) and the two bolts (2) that secure the floor console base and duct assembly to the center floor panel. Tighten the nuts and bolts to 5 Nm (45 in. lbs.).
3. If removed, install the front and rear console support brackets (3 and 5), rear blower motor housing (4) and the hands-free module (6). Tighten the screws to 2 Nm (17 in. lbs.).
4. Install the gear shift assembly .
5. Install the body wire harness bracket onto the rear console support bracket.
6. Connect the body wire harness connector (12) to the floor console mode door actuator (9)
7. Connect the body wire harness connector (11) to the rear blower motor power module (10).
8. Connect the body wire harness connector (8) to the hands-free module.
9. Reconnect the negative battery cable.
10. Install the front and rear center floor console covers . Floor Console - Installation