Front Wheel Speed Sensor - Installation

INSTALLATION

1. Apply bearing grease (supplied with part) to sensor head shaft and O-ring.

CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.





2. Push sensor head (4) into mounting hole in hub and bearing (2) and align mounting screw hole.
3. Install NEW mounting screw (1). Tighten mounting screw to 6 Nm (55 in. lbs.).
4. Place wheel speed sensor cable grommet into routing clip (3) at knuckle and close clip or push routing clip on cable into mounting hole in knuckle.�




5. Attach wheel speed sensor routing bracket (3) to strut assembly (1). Tighten screw (2) to 13 Nm (115 in. lbs.).




6. Clip wheel speed sensor connector and routing clip (3) to frame rail outer reinforcement.
7. Connect vehicle wiring harness (1) to wheel speed sensor connector (2).
8. Install brake rotor as well as all components necessary to access it. Brake Rotor - Installation
9. Verify that wheel speed sensor cable is properly routed and not coming into contact with rotor or other moving parts.
10. Road test vehicle to ensure proper operation of the base brakes and ABS.