Automatic Adjuster Unlocking

AUTOMATIC ADJUSTER UNLOCKING

1. Assure that all cables are connected properly.

WARNING: Do not release the automatic adjuster lockout device unless the parking brake cables and equalizer are connected. Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could lead to serious injury.





2. Keeping hands clear of automatic adjuster sector and pawl area, firmly grasp pin punch (drill bit, or locking pin if a new lever has been installed) (2) installed in lever mechanism, then quickly remove it from parking brake lever (1). This action allows parking brake lever mechanism to automatically take up any slack.
3. Cycle parking brake lever once to position parking brake cables, then return lever its released position.
4. Raise vehicle far enough for rear wheels to clear floor. Maintenance
5. Check rear wheels of vehicle. They should rotate freely without dragging with lever in released position.
6. Lower vehicle.