Installation

INSTALLATION

1. Slide leading end of front parking brake cable into hole in flange of lever. Slide cable retainer on end of cable housing into hole until retainer fingers click into place.




2. Pull button on end of cable strand out of housing and route around lever cam up to take-up reel.
3. Install front cable button (1) into lever take-up reel (2) as shown.
4. Slide any extra cable back into housing.




5. Position lever against left lower cowl (1) and install two mounting bolts (3) and one nut (2). Tighten all three fasteners to 28 Nm (21 ft. lbs.).
6. Install body control module mounting bracket. Install three mounting nuts and two wiring routing clips. Tighten all three fasteners to 14 Nm (125 in. lbs.).
7. Install body control module. Body Control Module - Installation




8. Connect wiring connector (1) at parking brake indicator lamp switch (2).
9. Connect parking brake release rod at parking brake lever.
10. Position carpet into place.
11. Install lower cowl trim.
12. Install left front door weather strip.
13. Install left front door opening sill scuff plate.
14. Raise and support vehicle. Maintenance




15. Route front cable above left rear brake tube and rear driveline module (1) (if equipped with AWD) to right rear parking brake cable (3).
16. While holding cable connector on end of front cable (5) secure with a pair of pliers at the front cable button, Place right rear cable button (4) into cable connector. Release cables allowing button to seat. It may take some hand pressure to completely seat button.
17. Place left rear parking brake cable button (2) into equalizer (10). Release cables allowing button to seat. It may take some hand pressure to completely seat button.
18. Lower vehicle.
19. Unlock automatic adjuster in parking brake lever. Service and Repair
20. Connect battery negative cable to battery post.
21. Adjust parking brake shoes. Adjustments