Disassembly

DISASSEMBLY





1. If the mounting bracket (2) needs to be removed from the ICU, loosen the two mounting nuts (1), then slide the mounting bracket off the two grommets and mounting pin (3).




2. Remove four screws (1) attaching antilock brake module (ABM) (2) to hydraulic control unit (HCU).




CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 inches)) before removing ABM. Otherwise, damage to the pressure sensor will result requiring HCU replacement.

3. Slide ABM (1) off HCU (2).