Disassembly

DISASSEMBLY

1. Clean the master cylinder housing and brake fluid reservoir. Use only Mopar(R) Brake Parts Cleaner or equivalent.
2. Remove the brake fluid reservoir cap. Empty as much brake fluid as possible from the reservoir.

CAUTION: When removing the fluid reservoir from the master cylinder, do not attempt to pry it off using any type of tool. This can damage the fluid reservoir or master cylinder housing.





3. Remove the screw (2) fastening the fluid reservoir (1) to the master cylinder housing.




4. Pull the reservoir (1) straight up and remove it from the grommet seals in master cylinder housing (2).




5. If the reservoir is being replaced, remove the fluid level switch (2). To do so, push up on the tab (1) at the bottom of the reservoir and pull the brake fluid level switch out.




6. Remove the vacuum seal (2) from the master cylinder mounting flange (1).