Second Row

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove headrest. Headrest - Removal.
3. Remove second row seat. Seat - Removal.
4. Disconnect heat element wire harness.
5. Remove two screws attaching outer side shield buckle side.
6. Remove screw attaching floor dump release handle and remove handle.
7. Remove front recliner handle (snaps on).
8. Remove three screws attaching side shield at recliner handle side.
9. Remove three screws attaching inner side shield hinge area.
10. Remove hinge to floor plastic cover.
11. Remove four screws attaching lower plastic cover, under side of seat.
12. Disengage J-straps and push pins at cushion cover.
13. Remove cushion and cover from seat pan.
14. Remove cover from cushion.