Operation

OPERATION

The sunroof is electrically operated from two switches located in the overhead console. The "VENT" switch is a push button type switch and opens the sunroof to the vent position only. The other switch "OPEN/CLOSED" is a rocker type switch for opening and closing the sunroof. Pressing and releasing the open button once, the sunroof will express open and the wind deflector will raise. If the button is pressed a second time the sunroof will stop in that position. Pressing and holding the close button will close the sunroof. If the close button is released the sunroof will stop in that position.

The switch is grounded at one terminal and receives a 12 volt signal from the sunroof motor/module on the remaining three terminals. The switch pulls down the 12 volt reference voltage from the motor/module signaling it to perform the desired function.

For complete circuit diagrams, refer to Diagrams/Electrical. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.