Sentry Key Remote Entry Module - Installation

INSTALLATION





1. Position the SKREEM on the ignition lock housing and install the retaining screw (1).




2. Position the ignition switch/lock assembly (3) up in behind the instrument panel and push rearward.
3. Install the two mounting nuts (1) to the front of the instrument panel.
4. From underneath the ignition switch/lock assembly, tighten the lower retaining screw (2).




5. Reach up behind the left side of the center stack and connect the ignition switch and SKREEM electrical connectors (5 and 6).




6. Position the instrument panel center stack left bezel (13) over retaining slots and firmly snap into place.
7. Install the knee blocker airbag Knee Blocker Airbag - Installation.

NOTE: After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the directions on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during this operation. There is no need to program the fob of the key for RKE functionality once the transponder key is programmed to the new SKREEM/WCM.

WARNING: Do not connect the battery negative cable Refer to appropriate testing. Personal injury or death may result if the system test is not performed first.

8. Close hood.