EVIC Switch Input Stuck

EVIC SWITCH INPUT STUCK

For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
The Cluster power-up diagnostics will test the EVIC Button A/D port for either an open circuit, short to power or ground, or a stuck button exists.

- Set Condition:
This DTC will set when the Cluster detects the EVIC Mux Signal circuit is active for 30 seconds.





Diagnostic Test

1. DTC PRESENT

NOTE: Diagnose and repair any EVIC Switch Input Short or Open DTC's before proceeding with this test.

With the scan tool, record and erase DTC's.
Cycle the ignition switch from ON to OFF to ON.
With the scan tool, read DTC's.
Wait 30 seconds.
Does the scan tool display this DTC as active?

Yes

- Replace the Clock Module.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test