Power Windows

DDM/PDM-09-ORC MESSAGES NOT RECEIVED

For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
Whenever the ignition is in run or run/start position.

- Set Condition:
If the door module does not receive any messages from the Occupant Restraint Controller Module (ORC) within 5 seconds, this code will set.





1. CLEAR DTCS
With the scan tool, erase DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the scan tool, read DTC's.
Does the scan tool display: DDM/PDM-09-ORC MESSAGES NOT RECEIVED?

Yes

- REFER TO IPM-09-ORC Communication Fault IPM-09

No

- No problem found at this time. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness connectors for broken, bent, pushed out, and corroded terminals.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test